smarterhost.blogg.se - Audio loopback samsung

#Audio loopback samsung how to
#Audio loopback samsung serial
#Audio loopback samsung software

YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT

Red wire below is ground, Green wire below is powerĭAKTRONICS DOES NOT PROMISE THAT THE CONTENT.

#Audio loopback samsung serial

Serial Communication Radio Manual, ED-13932. The cable color in the image below is recommended Daktronics installation as per:.It is important to note the pinout prior to removing cable from TB2.

Step 6: Do a loopback test on the cable coming into the server radio by disconnecting and twisting together TX-P and RX-P, as well as TX-N and RX-N wires. Remove wires on TX-p, RX-P, TX-N and RX-N and jumper pins TX-P and RX-P together and TX-N and RX-N together. Step 5: Do a loopback test on the signal converter (Radio TX Interface J-Box). Note: a small flat blade screwdriver can be used to jump the pins on the male end of the serial cable.Step 4: Do loopback test on com port of the computer, serial cable or on the USB to serial adapter by jumping pins 2 & 3 on the 9pin male or female end. Refer to the image below. Note: If at any point the loopback test fails, please contact Daktronics Technical Support at 1-88. Note: After each test point it is important to reconnect everything before moving to next test point. Step 3: If loopback passes at test points, remove the loopback and test for it to fail.

#Audio loopback samsung how to

How to use the Radio Config (AeroComm Configurator) Utility, DD2605825.

Radio Configurator Utility can also aid in determining where failure may be occurring, or help with a point to start loop back testing.

Step 2: Start loopback testing. There are different areas that the test can be ran on to help isolate where the communication failure is located. How do you perform a loopback test using HyperTerminal to test a serial communication system? DD1994747.

Hyper Terminal will be used with Windows XP and earlier operating systems.

How to perform a loopback test to test a serial communication system using Tera Term, with or without Lantronix box., DD2331527.

Tera Term will be used with Windows Vista and newer operating systems.

PuTTY, Tera Term, or HyperTerminal to perform the loopback test. Follow: How to perform a loopback test with Venus 1500 v3 software?, DD2362884

Venus 1500 version 3.12 or older versions can be used to perform loop back testing, using Venus Administrator.

#Audio loopback samsung software

Step 1: Locate proper software that can perform needed functions for loopback testing.

This will tell us if loopback testing should start at the control computer or at the client radio.

Follow - How to use the Radio Config Utility (RCU), DD2605825.

Note: Prior to starting the loopback test we can run Radio Config Utility in an attempt to poll the server and client radios

Follow the instructions below to perform loopback testing.